TracVision R4SL, R5SL
1
Addendum
PLEASE READ!
Important Addendum to Your Product Manual
This addendum applies to the following TracVision
®
antenna models:
R4SL and R5SL.
Running Check Switch Tests for DISH Network in the Southwest
Due to the higher elevation angle in the Southwest to the 119 satellite,
follow the modified steps below to run the receiver Check Switch tests
for a DISH Network configuration.
1.
Park the vehicle in a blockage-free area. Ensure the
antenna has an unobstructed view of the entire
southern sky.
2.
Ensure the receiver you wish to configure is connected
to the the antenna’s RF1 cable.
3.
Apply power to the TV and receiver.
4.
If the antenna is turned off, turn it back on and wait two
minutes for system startup.
5.
Using the receiver’s remote, go to the “Point Dish/
Signal Strength” screen (press MENU, 6, 1, 1 on most
models).
6.
Choose
Check Switch
, then press SELECT.
7.
Choose
Test
, then press SELECT.
This addendum only applies if the vehicle is located in the
southwestern U.S.
(California, Nevada, Arizona, New Mexico,
Texas, or Oklahoma)
and you need to configure the system for
DISH Network
®
service.
IMPORTANT!
ECO #8505
