MultiSat Control Panel Owner’s Manual
23
Chapter 2 - Installation
Wiring the HDTV Converter and Receiver
To configure your TracVision system for DIRECTV HDTV, follow the
steps below to connect the HDTV converter between the MCP and
your DIRECTV HDTV receiver.
1.
Connect an RF coax cable from the “HDTV Control”
jack on the MCP to the “Control Input” jack on the
HDTV converter (see Figure 2-19).
Figure 2-19 HDTV Converter and Receiver Wiring
2.
Connect the RF1 cable from the antenna to the “RF
Input” jack on the HDTV converter.
If you wish to connect multiple receivers, refer to the alternate
wiring diagrams in
.
IMPORTANT!
HDTV
CONTROL
ANTENNA UNIT
RF PORT
TONE
DETECT
FUSE
POWER IN
+ / –
MCP
HDTV
Converter
DIRECTV HDTV Receiver
SATELLITE IN
OUT TO TV
TV ANT/CABLE IN
AUDIO
VIDEO
S-VIDEO
PHONE JACK
R
L
SATELLITE IN
Splitter
OUT
OUT
INPUT
RF1 Cable
from Antenna
