7
Follow the steps below to drill the antenna
mounting holes.
a.
Place the mounting plate on the deck at the
location you chose in
. Ensure the mounting plate’s
forward arrow points towards the bow of the
b.
Using the mounting plate as a template, lay
out the locations for the six mounting holes.
Then drill the six 3/8" (9.5 mm) holes in the
mounting surface.
CAUTION
For your own safety, shut down vessel
power before you drill or connect wires. Test
the circuit to ensure no power is present.
21.11"
(536 mm)
24"
(610 mm)
26"
(660 mm)
4.73"
(120 mm)
1.57"
(40 mm)
1.18"
(30 mm)
4"
(101 mm)
19.28"
(490 mm)
Mounting
Plate
Radome
Bow
Mounting
Plate
Baseplate
Connectors
Centerline
Vessel
Forward
Arrow
Forward
Arrow
16.01"
(407 mm)
6.42"
(163 mm)
Figure 10: Mounting Plate Orientation
The locations of the mounting holes may
vary slightly from one mounting plate to the
next. Use the dimensions shown in Figure 10
for general reference only; use the mounting
plate itself as a template to lay out the holes
in the mounting surface.
IMPORTANT!
Drill the Mounting Holes
5
