20
Follow the steps below to set up the system for
your desired satellite TV service (if necessary)
and test the system for proper operation.
a.
Stop the vessel in a blockage-free area. The
antenna requires an unobstructed view of the
sky to receive satellite signals.
b. DISH Network or Bell TV only:
Follow the step-by-step setup instructions
provided in the
User’s Guide
to configure
your DISH Network or Bell TV receiver(s) for
your selected TracVision mode.
c.
Turn on the receiver(s) and TV(s). For details
on operating the receiver, refer to your
selected receiver’s user manual.
d.
Set the switchplate’s POWER switch to the
ON (|) position (see Figure 33). Within a few
minutes, a picture should appear on the TV.
e.
When you have finished testing, set the
switchplate’s POWER switch to the OFF (O)
position.
Each DISH Network or Bell TV receiver must
be configured to work with the TracVision
system, as explained in the
User’s Guide
.
IMPORTANT!
Figure 33: Switchplate ON/OFF Switch
MAINTENANCE
OFF
ON
Set Up and Test the System
17
