Operator’s manual for Pentruder 8-20HF/iQ and Pentpak HF-power pack – Original instructions
Page 9
Intended use of the Pentruder 8-20HF / 8-20iQ and Pentpak HF-power pack
The Pentruder 8-20HF / 8-20iQ is intended to be used together with a Pentpak HF-power pack and
may only be used for cutting of concrete and similar materials. It is our expressed recommendation
that the machine
not
be used for cutting in any other materials. The Pentruder 8-20HF/iQ can not
be used with other types of power packs. If connected to other types of power packs (frequency
inverters) Tractive AB disclaims any responsibility for the product.
Warning! Observe that Tractive’s responsibility as a manufacturer can only be accepted when
the saw head, Pentruder 8-20HF/i!, is used together with power packs, machines and
accessory equipment of Tractive’s manufacture and origin. If the Pentruder saw head is used
with non-original equipment the warranty will be void.
The Pentpak is primarily intended to power the Pentruder HF-wallsaws. It can also be used for
powering other machines of our manufacture, like the MD1, 4-speed drill gearbox, as well as our
wire saws. Please contact your dealer for information. Please observe that Tractive’s responsibility
as a manufacturer only can be accepted when the Pentpak is used together with machines and
accessory equipment of Tractive’s manufacture and origin.
Important! Always consult Tractive AB or our representative before any other type of machine
or equipment than the Pentruder 8-20HF/8-20iQ is connected to the power pack. Observe that
Tractive’s responsibility as a manufacturer can only be accepted when the saw head Pentruder
8-20HF is used together with power packs, machines and accessory equipment of Tractive’s
manufacture and origin.If the Pentruder saw head is used with non-original equipment the
warranty will be void.
Safety precautions
It is of paramount importance that the operator has full knowledge and understanding of the
instructions below:
This wall saw may not be used unless the operator is fully familiar with the contents of this manual
and has been trained in its operation by an authorised distributor of Tractive AB’s products. The
operator is fully responsible for the manner in which the machine is operated. It is the responsibility
of the purchaser that the operator has received the information needed to operate and handle the
machine in a safe a correct way.
Warning! Faulty handling of the machine can expose the operator and / or persons in close
proximity to the machine to danger.
Tractive AB disclaims all responsibility for damages to persons and / or property resulting from use
of the machine, whether they are caused by faulty handling or from damages that have occurred as
a consequence of negligent or faulty maintenance, or as a consequence of failure to check and
control the machine with regard to damages and / or faults.
Warning! A Pentruder wall saw used in the correct way is a safe and efficient tool. If the
machine is used improperly this can expose the operator and other persons staying in the same
area to extreme danger or even risk of fatal injuries.
Warning! Basic safety precautions are that all persons present in the same area or in the same
place as the machine shall wear protective equipment including helmet, safety shoes, gloves,
eye and ear protection, and that all other safety precautions applicable on site are to be
respected.
Warning! A saw blade rotates at up to 60 m/s peripheral speed, i.e. over 200 km/hour (120
mph). The energy stored in such a blade is considerable, and it is always important that the
