BCS 56cm Rotary Mower Attachment
TWT/56RM/0617
Page 7
Operation
Before starting the engine, set the cutting height on the
mower deck by adjusting lever H (fig 12).
Use handlebar height adjuster to set handlebar height
before commencing work.
NOTE
: Disengage the drive to the mower before selecting
reverse gear.
Raise the throttle to speed, release the clutch lever gently
and fully, keeping the red machine stop lever (OPC)
depressed as engine will stop if released.
Increase throttle speed.
The cutting height ranges from 2” to 4”. It is recommended
that a maximum of 2” be removed at each mowing, then
reduce it to a desired height with a second mowing.
Mowing wet grass is not recommended as it may clog the
discharge chute and make collection difficult.
Best results are obtained with the engine at a high throttle
setting.
Forward motion speed should be selected according to the
grass conditions.
Use speed two for light conditions and speed one for
difficult conditions.
Never allow the engine to labour.
The mower has a built-in blade brake which stops the blade
if the drive is disconnected.
When using the grass bag, it is full when grass comes out
of the hole of the back plastic chute (fig 13).
Always disengage the PTO before removing the grass bag
(fig 14).
Fig 12
Fig 13
Fig 14
Fig 15
