Rev1F
Coyote RT Temperature Probe Installation
*Must Use Coyote Wiring Harness 5C260*
Sensor Wiring (see table and pictures below)
Step#1:
*DO NOT Cut Both wires simultaneously or you will short the data bus*
->Cut off the 2-pin Molex blue/white and black wire connector on the Coyote RT 5C260 Harness
Step#2: Use butt connectors or solder to connect the Coyote 1-wire leads to the Temperature Sensor. Refer to the wiring chart below.
Step#3: Mount the Probe--Probe can be flush-mounted or the entire probe protruding in area to be monitored. Sensor can be easily
fastened using Silicon. Be sure NOT to cover the metallic part of the probe.
Temperature Sensor Wiring
Function
Coyote RT Wiring (1-wire
connection)
White
1-Bit Bus Data
Blue/White
Black
1-Bit Bus Ground
Black
Blue
1-Bit Bus Ground
Black
Red
Not Used
Step #1
Step #2
