•
From the main menu select
System
•
From the system menu select
Charge
•
Highlight required charge rate and press
<OK>
•
Press
<cancel>
to return to main menu
Note:
The fast charge option is only available when the instrument is
switched on. The instrument will also charge at a trickle rate if the instrument
is connected for charging but not switched on.
Driver Installation
Your Metalyser
®
is compatible with most computers with a USB socket, but first
the USB drivers may need to be installed. The drivers are located on the
Software USB stick provided for all versions of Windows post Windows 95.
•
Insert the USB memory stick into an available USB port on your PC
•
Connect the USB cable supplied to the Metalyser
®
instrument as
described for battery charging. Connect the other end to an available USB
port on your PC
•
Windows will run the ‘install new hardware wizard’
•
When asked if Windows can connect to Windows update to search for
software. Select ‘No, not this time’
•
Select ‘Install from a list or specific location’, navigate to USB memory
drive
•
Windows should install the drivers
•
Once complete, the wizard will run again. Use the same settings as
before
•
Once Windows has installed the drivers, reboot the computer and your
Metalyser
®
should be installed
•
To verify correct installation select fast charge on the instrument and
check that the fast charge icon (see page 7) is displayed on the Metalyser
®
’s
screen
4.2 Powering up the system
Turn on the Metalyser
®
instrument by pressing the power button. The
display will come on.
Next press and hold the power button on the tablet PC for 5 seconds
before releasing. The lights should now come on and the instrument will
start up. Windows will load and request a log-on. Please enter:
Username
: HM3000
Password
: <None>
It is recommended the password is changed to one of your personal
choosing.
Metalyser® Field Pro HM3000 Instruction Manual v 5.0
www.trace2o.com
18
