3.0 OPERATION
22
©2000 Xantrex/Trace Engineering
Figure 18
Replace Circuit Breaker Cover and Screws
Start-up Procedure
(continued)
6.
Replace the circuit breaker panel (Figure 18).
Install the circuit breaker (inner) panel by sliding it in-place under the top cover and fitting
its two locking tabs into the slots on the bottom of the ST unit.
Reinstall the two screws located on the bottom of the unit.
Reinstall the screws on the front of the panel that secure it to the circuit breaker.
Figure 19
Replace Outer Cover and Screws
7.
Replace the external cover. (Figure 19).
Position the external cover in place and install a screw in each side.
NOTE: A hole at the bottom front of this cover and the main chassis allow for installing a lock to
prevent tampering or unauthorized access to the unit.
Replace screws in the
circuit breakers
Replace screws into the tabs
Replace screw
(one on each side)
Lock Hole
