5
Place side panels on end with decal
outward and about a foot apart at
top. Place screen with latch, ( rear
screen), on end between sides with
latch outward and to the floor.
Attach to sides with 1/4 x 1/2 bolts.
Place screen without latch, (front
screen), on top of rear screen and
between sides. Secure to rear
screen with 1/4 x 1/2 bolts. Slip
deflector between sides and front
screen with tapered end up.
Secure with 1/4 x 1/2 bolts.
Place front on sides with flanges on
outside . Start corner bolts in sides
and screen before tightening. Start
bolts at top & bottom of side panels
and work your way toward center,
with truss head, round, to the outside.
Place cover flat on floor and attach angles
to side panels at rear of cover with angles
on the outside of cover. Secure with 1/4 x
1/2 bolts. Start at the top and second hole
from the bottom, (latch uses bottom hole),
then work towards the center of the panels.
Bolts truss, (round), head should be to the
inside of cart.
Attach handle to tailgate on smooth
side. Place cover on cart. Make sure
the two lower black angle brackets
have been installed on the lower rear
of the cart. Fit tailgate to the cover
using the top latch and lower brackets
only.
Place latch on each side of cart with
tongue of latch to rear. Attach to
side panel and cart with 1/4 x 1/2 bolts.
Place connector, (packed in with vac),
on outside of front with the lip to the
outside. Attach with 1/4 x 1/2 bolts.
Model 280 Cart Cover Assembly Instructions
Gently move cover to the rear to insure
contact between the tailgate and cover,
(along entire contacting surface). Center
1/4 x 1/2 bolts.
drill 9/32" holes. Attach cover with
front on cart. Mark hole locations, and
NOTE: Do not tighten any bolts until the end of construction.
Tighten all hardware.
