Instructions for mounting / schematic
TR-Electronic GmbH 2010, All Rights Reserved
Printed in the Federal Republic of Germany
Page 30 of 32
TR - ECE - BA - DGB - 0075 - 06
02/14/2018
4.2 Assembly type 2: Version with torque holder (sheet-metal spring)
The rotating of the measuring system by the arising torque is prevented by a torque
holder. Additionally occurring axial or radial displacements of the drive shaft will be
compensated and machine vibrations absorbed.
The torque holder basically can be mounted on both sides.
In case of version
(A)
the minimum thickness of the assembly plate corresponds to the
mounting shaft thickness (6.5 mm) plus 1 mm safety distance. In case of version
(B)
the minimum thickness of the assembly plate depends not on the mounting shaft of
the measuring system.
Mount measuring system with the torque holder and the two M4 screws onto the
assembly plate (machine) and protect it against slipping on the shaft by tighten the two
grub screws with the hexagon key.
Figure 4: Version with torque holder (sheet-metal spring)
The minimum length of the customer shaft depends on the measuring system length:
X Measuring system
60,5 mm
48 mm
40 mm
Y Customer shaft
72 mm
58 mm
45 mm