10/20 Product Code: RL12TPB
Made in China to TQB Brands Pty Ltd specifications
Page 6
Visit us at www.tqbbrands.com.au
6.
Place ram handle over release valve.
7.
Twist handle clockwise to close valve.
8.
Insert handle into fulcrum, then pump handle until pipe reaches bending die.
9.
Continue pumping slowly until desired angle is reached. Keep in mind that pipe may
rebound slightly, therefore you may need to bend very slightly beyond your desired
bend to get the correct bend. Practice on a scrap work piece first.
10.
Place ram handle over release valve.
11.
Twist handle counter-clockwise to open the valve and lower the piston.
12.
Remove pipe. If necessary, remove roller(s) to allow room to remove pipe.
4.
MAINTENANCE
Inspection:
Inspect the product for damage, wear, broken or missing parts and that all
components function before each use. DO NOT use damaged equipment.
1.
Change the hydraulic oil at least once a year.
2.
Remove ram from pipe bender by removing the two bolts.
3.
With the ram fully retracted, remove the oil fill plug.
4.
Tilt the ram to allow the old hydraulic oil to drain out of the housing completely,
dispose of the old hydraulic oil in accordance with local regulations.
5.
With the ram upright, completely fill the hydraulic ram with a high quality hydraulic
oil (not included) until the oil just begins to run out of the oil fill hole.
6.
Open the release valve and pump the handle to bleed air from the system.
7.
Reinstall the oil filler plug.
8.
Clean with a clean cloth using a mild detergent.
9.
Always store the hydraulic pipe bender in a safe, dry location.
5.
STORAGE
