6. Retrieving Logged Data
Logged data can be displayed on the 1008 display or sent to a PC by using the
USB cable and software included. The PC software also provides the capability of
real time monitoring from a PC.
Recalling and Displaying Logged Data
Retrieving Logged Data via PC
To retrieve logged data the USB cable and PC software (both supplied) must be
used.
Install the PC software on your PC and open it.
Connect the 1008 to the PC using the USB cable.
Run the software and select 1008 when prompted. Click on the connect to PC
button in the software window.
The software can be used to retrieve logged data and for real time monitoring.
COM port setting is:
Baud rate: 19200
Parity: None
Data Bits: 8
Stop Bit: 1
1) Press the
key, “LOG 01” and the logged CO2 and temperature reading
will alternately flash. Press the
to cycle through all of the logged
data.
2) To deactivate recall mode and return to normal operation, press the
key.
4.2 Selecting Temperature Units
4.3 Min / Max Mode
4.4 Activating the Backlight
Pressing the
key activates Min/Max mode and “Max Min” will be displayed.
In this mode the 1008 will keep track of the minimum, maximum, and average
CO2 and Temperature being measured. When “Min Max” is displayed the 1008
will display the real time reading.
Pressing the
key switches the temperature display between °F and °C.
To deactivate Min/Max mode and return to normal operation, Press and hold the
key until the 1008 beeps.
Pressing the
key turns the display backlight on and off. Power
consumption is much higher when the backlight is activated. The backlight
will automatically turn off 30 seconds after it is activated. To conserve bat-
tery life the backlight should only be used when necessary.
Pressing the
key will cause the 1008 to display “MAX”. This indicates the
Maximum CO2 and Temperature measured is displayed.
Press the
key again and the 1008 will display “MIN”. This indicates the
Minimum CO2 and Temperature measured is displayed.
Press the
key again and the 1008 will display “AVG”. This indicates the
Average CO2 and Temperature measured is displayed.
Pressing the
key will cause the 1008 to display “MAX MIN”. This indicates
the real time reading is displayed and the Min/Max mode is still active. The steps
above can be repeated to cycle through the Min, Max, and Avg displays.
w
w
w
.
G
lo
ba
lT
es
tS
up
pl
y
.c
om
Fi
nd
Q
ua
lit
y
Pr
od
uc
ts
O
nl
in
e
at
:
sa
le
s@
G
lo
ba
lT
es
tS
up
pl
y.
co
m
