REV. LEVEL: A
ECO 1-7565
REV. DATE: 9-2019
FORM:8979
1 OF 4
INSTALLATION AND OPERATION
INSTRUCTIONS
3200 SERIES
INSTALLATION
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Caution:
To prevent electric shock disconnect power to heater at main service before wiring or service.
Attention:
pour éviter tout risque d’électrocution, déconnectez l’alimentation de l’appareil de chauffage lors de l’entretien
principal avant le câblage ou l’entretien.
Caution:
Do not obstruct the front of the heater with curtains, furniture, doors, etc. Do not place heaters under towel racks.
Proper operation of the heater requires a free flow intake and exhaust of air.
Attention:
Ne bloquez pas l’avant du radiateur avec des rideaux, des meubles, des portes, etc. Ne placez pas de radiateur
sous le porte-serviettes. Le bon fonctionnement de l’appareil de chauffage nécessite une entrée et une sortie d’air libres.
GENERAL
These heaters are designed for 2 X 4 recessed or surface mount installation. The 3200 series heaters may be wall mounted
in a vertical position with top discharge, or horizontal position with right or left discharge. The minimum clearance for the
3200 series is 12 inches to the adjacent wall and 6 inches minimum from the floor. These heaters must not be installed
without wallbox model no. BOX 30WB.
INSTALLATION OF WALL BOX 30WB
FOR NEW CONSTRUCTION
1.
Position the wall box, maintaining minimum clearances as stated above. Secure to wall stud with nails or screws. Wall
box
2.
Must be installed with front edge flush with finished wall surface. See figure 1. Remove knockout in wall box for power
source, and install cable clamp.
3.
Insert supply cable through clamp allowing 6-8” for field wiring.
NOTE:
Field wiring must enter the wall box on the left side of the fan end of the heater.
TPI Corporation 114 Roscoe Fitz Road, Gray TN 37615, www.tpicorp.com
Summary of Contents for 3200 Series
Page 2: ......
