10
If multiple ONTs of the same type bound to the same line profile or service profile are connected to
the same port, you can add ONTs in bulk by confirming all the automatically discovered ONTs to
make configuration easier and more efficient. To do so, the preceding command can be modified
as follows:
：
OLT(interface-gpon)
# ont confirm 4 all sn-auth ont-lineprofile-id 10 ont-srvprofile-id 10.
5.4 Check ONT Status
After an ONT is added, run the
show ont info
command to query the current status of the ONT.
Ensure that
Config flag
of the ONT is
active
,
Run State
is
online
,
Config state
is
success
, and
Match state
is
match
.
OLT(interface-gpon)
# show ont info 4 2
-----------------------------------------------------------------------------
PORT-ID: 4
ONT-ID : 2
Control flag :
Active
Run state :
Online
Config state :
Success
Match state :
Match
...// he rest of the response information is omitted.
When
Config state
is
failed
,
Run state
is
offline
, or
Match state
is
mismatch
:
If Control flag is
deactive
, run the
ont active
command in GPON mode to activate the ONU.
If
Run state
is
offline
, a physical line may be broken or the optical module may be damaged.
Check the line and the optical module.
If
Config state
is
failed
, the configured ONU capability exceeds the actual ONU capability.
If the ONU does not match, that is,
Match state
is
mismatch,
the port types and number of
ports do not match the actual port types and number of ports supported by the ONU. In this
case, run the
show ont capability
command to query the actual capability of the ONU, and
then select right one.
5.5 Configuring SFU (Bridge ONT)
This topic describes how to configure Internet access service when SFU is used to build an FTTH
network.
Prerequisites
The OLT is connected to the uplink device successfully
The ONT has been added to the OLT. For details, see chapter 4.3.
The VLAN of the LAN switch port connected to the OLT uplink port is the same as the uplink
VLAN of the OLT.
Data Plan
Item
Data
ONT Line Profile
Line Profile: 10
