60
Chapter 11
Specify Your Network Settings
How can I do that?
1
Make sure the routers use different LAN IP addresses on the same subnet. Disable
DHCP function of Router 2.
2
Visit
, and log in with the password or your TP-Link ID.
3
Go to
Advanced
>
Network
>
Static Routing
.
4
Click
Add
to add a new static routing entry. Finish the settings according to the
following explanations:
•
Network Destination
- The destination IP address that you want to assign to a static
route. This IP address cannot be on the same subnet with the WAN IP or LAN IP of the
router. In the example, the IP address of the company network is the destination IP
address, so here enters 172.30.30.1.
•
Subnet Mask
- Determines the destination network with the destination IP address.
If the destination is a single IP address, enter 255.255.255.255; otherwise, enter the
subnet mask of the corresponding network IP. In the example, the destination network
is a single IP, so here enters 255.255.255.255.
•
Gateway
- The IP address of the gateway device to which the data packets will be
sent. This IP address must be on the same subnet with the router’s IP which sends out
the data. In the example, the data packets will be sent to the LAN port of Router 2 and
then to the Server, so the gateway should be 192.168.1.2
Summary of Contents for Archer MR600
Page 1: ...REV1 1 0 1910012622 User Guide AC1200 4G LTE Advanced Cat6 Gigabit Router...
Page 14: ...Chapter 3 Log In to Your 4G LTE Router...
Page 72: ...68 Chapter 11 Specify Your Network Settings 4 Select Use my Internet connection VPN...
Page 112: ...108 4 7 9 1 4 7 9 2 BSMI Notice Pb Cd Hg CrVI PBB PBDE PCB 1 0 1 wt 0 01 wt 2 3...