Toyotomi TKN/TKG-A528DV, User Manual

Page: 55 / 60

55
GB
Dehumidifying operation
Ensure the unit is plugged in and power is available. The OPERATION indicator on the display
panel of the indoor unit starts
fl ashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the desired temperature.
3. Press the ON/OFF button to start the air conditioner. The temperature
can be set within a range of 17ºC~ 30ºC in 1ºC increments
NOTE
In the Dehumidifying mode, you can not switch the fan speed. It has already been automatically
controlled.
Adjusting air fl ow direction
Use the SWING and DIRECT button to adjust the desired air fl ow direction.
1. When push the DIRECT button, the horizontal louver changes 6 degree in angle for each push.
2. When push the SWING button, the louver will swing up and down automatically.
NOTE
When the louver swing or move to a position which would affect the cooling
or heating effect of the air conditioner, it would automatically change the
swing/moving direction.
Timer operation
Press the TIMER ON button can set the auto-on time of the unit. Press the TIMER OFF button can
set the auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote controller shows TIMER ON, the last Auto-on setting
time and the signal «h» will be shown on the LCD display area. Now it is ready to reset the Auto-
on time to START the operation.
2. Push the TIMER ON button again to set desired Auto-on time. Each time you press the button,
the time increases by half an hour between 0 and 10 hours and by one hour between 10 and
24 hours.
3. After setting the TIMER ON ,there will be a one second delay before the remote controller
transmits the signal to the air conditioner. Then, after approximately another 2 seconds, the
signal «h» will disappear and the set temperature will re-appear on the LCD display window.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote controller shows TIMER OFF, the last Auto-off setting
time and the signal «h» will be shown on the LCD display area. Now it is ready to reset the Auto-
off time to stop the operation.
2. Push the TIMER OFF button again to set desired Auto-off time. Each time you press the button,
the time increases by half an hour between 0 and 10 hours and by one hour between 10 and
24 hours.
3. After setting the TIMER OFF ,there will be a one second delay before the remote controller
transmits the signal to the air conditioner. Then after approximately another 2 seconds, the
signal «h» will disappear and the set temperature will re-appear on the LCD display window
REMOTE CONTROLLER