10. Install the wick sleeve with wick to the primary air
tube. And then turn the wick sleeve clockwise to
set the handle arm.
7. Place the knurled wick adjustment knob on the wick mechanism. Turn the knob
as far to the right as possible.
8. Turn the wick sleeve counterclockwise and lift the wick sleeve with wick up. Remove
it from the primary air tube.
NOTE:
Install the wick to the wick sleeve according to
the allowed direction engraved on the sleeve.
9. Squeeze the wick to loosen the three wick pins and remove the wick from the
wick sleeve. Ensure that you are wearing gloves and that you have a container in
which to put the kerosene wick.
Install the new wick to the wick sleeve according to the allowed direction
engraved on the wick sleeve.
Pin
Handle arm
Handle arm
Engraved mark
Hole of wick
sleeve
Guide pin
Hole of wick
sleeve
Guide pin
Wick sleeve
Pin
Wick sleeve
Handle arm
11. Operate the wick adjuster knob to be sure the wick moves smoothly up and
down.
12. Put the wick holder back
13. Make certain the top plat
the top of primary air tub
they are uneven, the fla
too. And tighten the four
wick holder.
Note: The space betwe
the primary air tu
around.
14. Operate the wick adjus
down. After replacing
extinguisher.
15. Wick height on position
wick adjuster knob fully c
Pull out the wick adjuste
16. Replace the cabinet and
17. Tighten the three (3) scre
screwdriver.
11
RCA-37WX_US.qxd 15.10.22 10:26 ページ 11
m
e
12. Put the wick holder back into position.
13. Make certain the top plate of the wick holder and
the top of primary air tube are the same height. If
they are uneven, the flames tend to be uneven,
too. And tighten the four (4) wing nuts around the
wick holder.
Note: The space between the wick holder and
the primary air tube should be even all
around.
14. Operate the wick adjuster knob to be sure the wick moves smoothly up and
down. After replacing the wick, check the operation of the automatic
extinguisher.
15. Wick height on position
1
of wick life extender should be 8 mm (5/16 in.) when
wick adjuster knob fully clockwise. Be sure to check.
Pull out the wick adjuster knob from the wick adjuster shaft.
16. Replace the cabinet and secure it into position.
17. Tighten the three (3) screws at the side and rear of the cabinet by using the
screwdriver.
Space
Wick
Primary
air tube
Wick
holder
Top of
primary
air tube
Top of
wick
holder
12
RCA-37WX_US.qxd 15.10.22 10:26 ページ 12
