6
TIMER IGNITION
Your heater can be arranged to ignite automatcally at a chosen time by use of a pre-set
“
Timer
”
. This
“
Timer
”
can only be set after the clock setting has been completed.
1
4
3
2
1. Press the
key and then the
“
Timer
”
key immediately after
that. The Timer Lamp will start blinking.
2. To set the
“
Timer
”
to the chosen igntion time, you should follow
the same procedure as given earlier for
“
Clock
”
time setting.
After approximately 10 seconds, the digital indicator will return
to
“
Clock
”
mode, displaying the present time.
3. Your heater will now automatically start up the pre-set time.
4. If you wish to start up the heater at the pre-set time again, repeat the same procedure 1.
mentioned above.
NOTE: The pre-set time will remain so long as the heater receives electrical power. In the
event of power failure or disconnection of heater for more than 10 minutes, timer
setting will be cancelled.
NOTE: If normal ignition was used to set the heater burning (i.e. the heater is burning but
the Timer Lamp on the Indicator panel is out), pressing the Timer key will extinguish
the heater, and the heater will be put into the
“
Timer
”
mode.
