Toyotomi LC-33, Instruction Manual, Page: 8 / 16

6
TIMER IGNITION
Your heater can be arranged to ignite automatcally at a chosen time by use of a pre-set
“Timer”. This “Timer” can only be set after the clock setting has been completed.
1. Press the button and then the “Timer” key immediately
after that. The Timer Lamp and Digital Indicator will start
blinking.
2. To set the “Timer” to the chosen igntion time, you should
follow the same procedure as given earlier for “Clock” time
setting. After approximately 10 seconds, the digital indicator
will return to “Clock” mode, displaying the present time.
3. Your heater will now automatically start up the pre-set time.
4. If you wish to start up the heater at the pre-set time again, repeat the same
procedure 1. mentioned above.
NOTE: The pre-set time will remain so long as the heater receives electrical power.
In the event of power failure or disconnection of heater, timer setting will be
cancelled.
NOTE: If normal ignition was used to set the heater burning (i.e. the heater is
burning but the Timer Lamp on the Indicator panel is out), pressing the Timer
key will extinguish the heater, and the heater will be put into the “Timer”
mode.
TEMPERATURE REGULATION
1. Use the adjustment keys (
▼
hour/
▲
min.) to adjust the
temperature.
2. Adjust the temperature using the key on the right (
▲
min.) to
set the temperature to a higher setting and the key on the left
(
▼
hour) to lower the temperature.
3. Until the room temperature has reached the set temperature, the heater will burn at
either high or medium burning mode. When the room temperature reaches or
slightly exceeds the set temperature, the heater will automatically shift to maintain
the desired temperature.