![Toyotomi FF-V30T Installation And Operation Instructions Manual Download Page 8](http://html1.mh-extra.com/html/toyotomi/ff-v30t/ff-v30t_installation-and-operation-instructions-manual_1143439008.webp)
☞
empty
full
RESET
TEST
3. Prior to use
Step 1: Filling fuel
• Do not fill the removable tank in the living
room, but in a more suitable place (there
can always be some spillage).
• Do not refuel the heater while in operation
or still hot.
Follow the procedure below:
[1] Make sure that the heater is switched off.
[2] Open the tank lid and lift the removable tank out of
the heater.
Note: Some drops may leak from the tank. Put down
the removable tank (cap pointing upwards) and
screw off the fuel cap using the fuel cap cover.
[3] Take the manual fuel pump and insert the smooth,
most rigid tube into the can. Make sure that it is in a
higher position than the removable tank. Insert the
ribbed hose into the opening of the removable tank.
[4] Lock the switch button on top of the pump (turn
clockwise).
[5] Squeeze the pump a few times, until fuel starts
flowing into the removable tank. As soon as this
happens, there is no need to press any longer.
[6] Check the removable tank fuel gauge while filling the
tank. Stop filling by loosening the switch button on
top of the pump (turn anti-clockwise), once the
gauge indicates that the tank is full. Never overfill
the tank, especially not when the fuel is very cold
(fuel expands when it heats up).
[7] Let the remaining fuel in the pump flow back into the
can and carefully remove the pump. Carefully screw
the fuel cap back on the tank using the fuel cap
cover. After use, re-store the cover at the rearof the
heater. Clean off any spilled fuel.
[8] Check whether the fuel cap is straight an tightened
properly. Reinstall the removable tank in the heater
(cap down). Close the tank lid.
Step 2: Plug in the heater
Insert the plug into the wall-socket (230 Volts –
AC/50Hz).
Step 3: Setting the clock
Important: The clock on the heater must always be set
to the correct time.
It is only possible to set the correct time, when the
heater is connected to the mains and not burning.
Use the adjustment buttons to set the time. First
press either of the two buttons to switch on the
empty full
7
FF-V30T (E) 07.11.8 11:17 AM ページ 7