Toyotomi FB-38N, Operation And Maintenance Instructions, Page: 11 / 41

11
SECTION D:
OPERATION
FUELING
WARNING: Use KEROSENE only. Never use gasoline, thinner, benzene, light oil or waste oil.
CAUTION: Make sure that the fuel is clean and free from dirt and water. Water and dirt may
cause combustion failure and shorten the life of components such as the Fuel
Pump. Be sure to refuel before the Tank runs out. Avoid having the Fuel Tank and
Fuel Pipe run empty.
REMOVING AIR TRAP
When operating for the first time or when refueling an empty Tank, air may be trapped in the
Fuel Pipe, making ignition difficult. In this situation, follow the procedures below:
1. Turn the unit off by pressing “POWER SWITCH”. Disconnect the
Power Supply Cord.
2. Release the two (2) screws from the Front Panel and remove the
Front Panel.
3. To catch the fuel which will drain out, put a small container under
the strainer.
4. Loosen the Screw on top of the Fuel Strainer. Immediately wipe
off any spilled fuel.
5. Remove the trapped air thoroughly. Failure to remove all the air
will cause improper ignition and may extinguish the unit.
6. Tighten the Screw after removing trapped air.
7. Plug into the receptacle. Tunn the unit on by pressing “POWER
SWITCH”.
NOTE: In the event of an ignition failure, Turn the unit off by
pressing “POWER SWITCH” and after 5 seconds press
“POWER SWITCH” once again.
INSPECTION BEFORE OPERATION
1. Check for water leaks in the Circulation Pipes.
2. Be sure there is a sufficient amount of fuel in the Fuel Tank and that there are no leaks in the
Fuel Pipe.
3. Be sure the Power Supply is properly connected and grounded to the unit.
4. Be sure the area around the Water Heater is clear of flammable materials such as gasoline,
thinner or flammable vapors.
5. Be sure the Exhaust Pipes are securely connected and that there are no leaks.