TOYOTA TVIP SYSTEM PROGRAMMING
Page 11
PASSIVE ARMING ON/ OFF SELECTION AND ENTRY DELAY TIME
SELECTION
The RS3200 PLUS is factory set to not passively arm. To change the system s operation for passive
arming, as well as to adjust the entry delay time, follow the procedure below.
1. Before you begin:
Close all the doors and the trunk or hatch, unlock all the doors with the inside
lock switch, then remove the key from the ignition switch.
a. Using a remote control,
lock,
then
unlock
the
doors
3 times.
2. Start
the
programming
procedure.
(Complete these steps within 30 seconds.)
b. Open
the driver s
door.
c. Lock,
then
unlock
the
driver s door
inside lock
button 3 times.
d.
The system locks the door
in 2 seconds; if this does
not happen, start over.
e. Unlock
the driver s door
inside lock button.
3. Select the operating mode and entry time delay, and complete the programming steps.
a. Close,
then
open
the door:
2 times= passive arming
off
3 times= passive arming
on
,
0 sec. entry delay.
4 times= passive arming
on
,
15 sec. entry delay.
5 times= passive arming
on
,
30 sec. entry delay.
b. Lock,
then
unlock
the
driver s door
inside
lock button 1 time.
c.
The system locks the door
in 2 seconds;
Programming is now
complete. If this does not
happen, start over.
