Disclaimer
Height Setting
Solution to Electric Tail Door Failure
Button control mode
The related problems and losses caused by improper installation and use are not covered by our
company's warranty. Please read this manual carefully before use. Please store carefully after reading,
so that you can check it later. The picture is for reference only. The product is subject to the actual object.
1: Long press on tailgate button for three seconds to open or close door on the original car remote control
2: Press once on the open/close door button on the front switch.
Raise the tailgate to the desired height, press the tailgate switch button, 3-5 seconds will appear a "beep" sound, loosen hand,
then press the tailgate button to close, the tailgate is closed, and there is a "beep" sound, that is, the tailgate programming is
completed
Fault Phenomenon
Troubleshooting
Whether the yellow center line connected properly
The original car remote control did not work
Does not work after installation is complete
Tailgate do not close properly
The original car remote cannot close the door
The tailgate does not go up halfway
Whether the left and right brackets of the poles are reversed
Whether the control box cables is plugged in properly
Whether the bracket is fixed or replaced with our special screw
Whether there is any programming after installation. The first time you install
on the car, you need to program by using the tailgate button once.
Programming steps; open the door and press and hold the door button for three
seconds. When you hear a click, release the hand and press the button again.
The tail door will automatically close and programming is complete.
Whether the left and right brackets of the poles are reversed
Whether the control box cables plugged in properly
Whether the bracket is fixed or replaced with our special screw
There are two vinyls on the left and right sides of the original rear door.
If it is loose, it needs to be tighten.
Check if the positive power supply is connected to 12V-16V
Check if the power cord fuse is plugged in.
Check if the ground wire is connected
