WWW.MANUALS.WS
WWW.MANUALS.WS
90
1 2 3 4 5 6 (Preset buttons)
These buttons are useed to preset and
tune in radio stations.
To preset a station to a button: Tune in the
desired station (see “TUNE”). Push and
hold down the button until you hear a
beep-this will set the station to the button.
The button number will appear on the dis-
play.
To tune in to a preset station: Push the
button for the station you want. The button
number and station frequency will appear
on the display.
These systems can store one AM and one
FM station for each button. The preset
station memeory will be canceled out if
the power source is interrupted (battery
disconnected or fuse blown).
AM
⋅
FM
Push “AM
⋅
FM” to switch between the AM
and FM brands. “AM” or “FM” will appear
on the display.
If the audio system is off, you can turn on
the radio by pushing “AM
⋅
FM”.
BAL (Balance)
This knob lets you adjust the balance be-
tween the right and left speakers.
Push“BAL/FADE” so that it pops out of its
retracted position. Turn the knob to adjust
the balance. Push the knob back into its
retracted position.
BASS
This knob lets you adjust the bass level.
Push “BASS/TREB” so that it pops out of
its retracted position. Turn the knob to ad-
just the bass. Push the knob back into its
retracted position.
FADE
This knob lets you adjust the balance be-
tween the front and rear speakers.
Push “BAL/FADE” so that it pops out of its
retracted position. Pull out the knob. Turn
the knob to adjust the front/rear balance.
Push the knob back into its retracted posi-
tion.
PWR
⋅
VOL (Power
⋅
Volume)
Push “PWR
⋅
VOL” to turn the audio sys-
tem on and off. Turn the “PWR
⋅
VOL”
knob to adjust the volume.
SCAN
When you push “SCAN”, the radio finds
the next station up the station band, plays
it for 5 seconds, and then scans again. To
select a station, push “SCAN” a second
time.
ST (Stereo reception) display
Your radio automatically changes to re-
ception when a stereo broadcast is re-
ceived. “ST” appears on the display. If the
signal becomes weak, the radio reduces
the amount of channel separation to pre-
vent the weak signal from creating noise.
If the signal becomes extremely weak, the
radio switches from stereo to mono recep-
tion.
TREB (Treble)
This knob lets you adjust treble level.
Push “BASS/TREB” so that it pops out of
its retracted position. Pull out the knob.
Turn the knob to adjust the treble. Push
the knob back into its retracted position.
TUNE
Tuning
Your Toyota has an electronic tuning radio
(ETR).
Push and release the “
∧
” (up) or “
∨
”
(down) side of “TUNE” to step up or down
the station band. If you hear a beep, you
held the button too long and the radio will
go into the seek mode.
