TOYOTA TUNDRA 2016
-
TONNEAU COVER
Procedure
Page 4 of 11 pages
Issue: C 04/18/2017
DIO
(d)
Align the slots in the clamp brackets with the
threaded holes in truck bed sides and install
the supplied mounting bolts (Fig. 2-4). Do
not fully tighten them at this time.
NOTE:
To ensure proper alignment of the driver
and passenger side pins, make sure that both side
rails are placed exactly the same (Fig. 2-5).
(e)
Tighten and torque the mounting bolts to 7.5
N-m (66.5 in-lbf), being sure to hold the rail
in place and PUSH the side rail DOWN
against the bed caps as the clamp is tightened
(Fig. 2-6).
Torque: 7.5 N-m (66.5 in-lbf)
NOTE:
The top of the rail must contact the truck
bed side wall to ensure a good seal (Fig. 2-7).
CAUTION:
If the vehicle is equipped with a
Toyota bed liner, ensure that the liner is not
sandwiched between the clamps and the truck
bed.
Fig. 2-4
T-30 Torx socket, ratchet & extension
Fig. 2-6
T-30 Torx socket & torque wrench
Fig. 2-7
Fig. 2-5
Tape measure
1 inch
