Toyota Highlander 2020, Owner'S Manual

Page: 200 / 560

200
4-2. Driving procedures
HIGHLANDER_U
4-2.Driving procedures
1
Check that the parking brake
is set.
2
Check that the shift lever is in
P.
3
Firmly depress the brake
pedal.
and a message will be dis-
played on the multi-information dis-
play.
If it is not displayed, the engine
cannot be started.
4
Press the engine switch
shortly and firmly.
When operating the engine switch,
one short, firm press is enough. It is
not necessary to press and hold the
switch.
The engine will crank until it starts
or for up to 30 seconds, whichever
is less.
Continue depressing the brake
pedal until the engine is completely
started.
The engine can be started from any
engine switch mode.
■
If the engine does not start
●
The engine immobilizer system
may not have been deactivated.
(

P.69)
Contact your Toyota dealer.
●
If a message related to start-up is
shown on the multi-information
display, read the message and fol-
low the instructions.
■
If the battery is discharged
The engine cannot be started using
the smart key system. Refer to
P.483to restart the engine.
■
Electronic key battery depletion

P.112
■
Conditions affecting operation

P.132
■
Note for the entry function

P.133
■
Steering lock function
●
After turning the engine switch off
and opening and closing the
doors, the steering wheel will be
locked due to the steering lock
function. Operating the engine
switch again automatically can-
cels the steering lock.
●
When the steering lock cannot be
released, “Push Engine Switch
while Turning Steering Wheel in
Either Direction” will be displayed
on the multi-information display.
Check that the shift lever is in P.
Press the engine switch shortly
and firmly while turning the steer-
Engine (ignition)
switch
Performing the following
operations when carrying
the electronic key on your
person starts the engine or
changes engine switch
modes.
Starting the engine