Toyota Celica 2000, Repair Manual

Page: 297 / 1151

ST-12
SST
"""'
STARTING
-
STARTER
(g) Tighten terminal nut.
( 1 )
Put a wooden block on the contact plate and press
it down with a hand press.
Dimensions of wooden block:
20
X
37
X
40
mm
(0.79
X
1 .46
X
1.57
in.)
Press force:
981
N
(100
kgf,
221
lbf)
NOTICE:
Check the diameter of the hand press ram. Then calculate
the gauge pressure of the press when
981
N
(100 kgf, 221
lbf) of force is applied.
Gauge pressure:
100
kgf
(kgflcm2)
=
Ram
2
x
3.14(11)
221
ibf
(psi)
=
2
x
3.14 (n}
(kpa)
.::: (kgflcm2)
x
98.1
(
k
pa )
=
(psi) x
6.9
If the contact plate
is
not pressed down with the specified pres­
sure, the contact plate may tilt due to coil deformation or the
tightening of the nut.
(2) Using
SST,
tighten the nuts to the specified torque.
SST 09810-38140
Torque:
17
N-m
(173
kgf.cm,
1 2
11-lbf)
NOTICE:
If the nut Is over tightened, it may cause cracks on the In�
side of the insulator.
(h) Clean contact surtaces of contact plate and plunger.
Clean the contact surtaces of the remaining contact plate
and plunger with a dry shop rag.
(i)
Reinstall magnetlc switch end cover.
Instal! the plunger, new gasket, end cover with tho
3
bolts.
Torque: 2.5 N-m (26 kgf.cm,
23
in.-lbf)