TCWS.38NG03.C 080709-12
6. Secure the burner tray to legs using
eight screws (Fig. #6)
NOTE: use a light to aid aligning the
holes in the tray with the leg.
NOTE: check air shutter for correct
setting for fuel before proceeding
further. Both primary air shutters
are to be set the same, fully closed
for natural gas. 1/8” (0.125)” open
for LP.
7. Install the right burner first by plac-
ing it into the center of the burner tray.
With the left end slightly elevated, slide
it to the far right. The primary air shutter
should engage fully with the main orifice.
Test for connection by lightly prying at
the end of the burner with a screw driver.
Repeat with left burner. (Fig. #7)
NOTE: The burners should be tightly
butted up against each other at the
center to ensure correct operation.
8. Place glass media into the burner
tray and brush smooth so that a
very light layer covers the burners.
(Fig. #8)
NOTE: Too much glass media will
cause sooting and improper flame
pattern.
9. Place rear porcelain trim, wide
edge, against the back panel and
press down over the pre-bent tabs
on the burner tray. (Fig. #9)
Fig #6
Fig #9
Fig #8
Fig #7
4
