The standoffs are shipped loose
inside the fi replace and must be
installed on the top and the side of
the fi replace as shown in Fig. #6.
Do this once the fi replace is on
site and in position.
In planning the installation for the fi replace, it is necessary to determine where the unit is to
be installed, location of vent system and where gas supply piping may be plumbed. Various
installations are possible, such as, into an existing wall, a corner, a built-in wall or a wall
projection (Fig. #7). Due to high temperatures, do not locate this fi replace in areas of high
traffic or near furniture or draperies.
The minimum clearances from the fi replace to combustible surfaces must be adhered
to and are shown in Fig. #2 and Fig. #3.
EXAMPLES OF COMMON LOCATIONS
SEE FIG #11 FOR DIMENSIONS
HANDLE
CONTROL
BOX
SIDE
STANDOFF
(THIS SIDE ONLY)
TOP STANDOFFS
Fig. #6
Fig. #7
7
TCWS.38CE3 011012-44
Locating The Fireplace
Standoffs
