4 TC42.NG01
110505-8
EMBER MATERIAL
A large bag of ember material is shipped with the fi replace
and needs to be installed to ensure optimum performance
and fl ame appearance.
Pull apart the material into ember size pieces (approximately
1” squares) and gently place them into the burner pan. Do not
compress, leave it loose for best performance. Fill the burner
pan level with the top of the pan at rear, and gradually sloping
forward down to the fi rebox fl oor at the front, covering both
burner tubes. Place remaining ember material outside of the
burner pan as desired to cover-up gas lines and brackets.
Note: Ember material placement and amount will affect fl ame
appearance. More ember material results in lower fl ame
height. Add or remove as needed until desired fl ame affect.
Reduce the amount used on Propane models, as too much
will create soot.
LOG SET ASSEMBLY
The logs are packaged in a foam pack inside the box, are
fragile, and should be handled with care. Unpack and inspect
log set. There should be a total of 6 logs. Gas plumbing and
vent connections should be completed before proceeding.
Position the logs as indicated by the following pictures. Place
the rear log back against the tabs located at the back of the
grate. Place left log as pictured, engaging the pins with cor-
responding holes on the underside of the log. Install the right
log into the grate and pull it forward into position as shown.
Install the middle log into the space between the left log and
the front of the grate as shown. Place the two remaining small
logs on the fl oor of the fi rebox as shown.
Step 1
Rear Log Placement
Step 2
Left Log Placement
1
2
Fig. # 7
GLOWING EMBERS
LOG
GRATE
Ember Material Placement
Fig. # 8
