6
Before First Use:
Read all instructions and safety information carefully before first use. Please retain this information
for future reference.
1.
Remove the parts from the packaging.
2.
Clean your kettle by going through several boiling cycles, using clean water with each
cycle and filling the kettle to its upper marking. The water will reach boiling point after
approximately 5 minutes. The kettle switches off automatically.
3.
Discard the boiled water. Wait for the kettle to cool, then rinse it with cold water.
4.
Your appliance is now ready for normal use.
5.
Dispose of the packaging in a responsible manner.
Using Your Appliance
1.
Fill the kettle using either the spout or lid. Open the lid by pressing the lid release button.
2.
We recommend filling the kettle to at least the 0.5L capacity mark but our special feature
means you can boil just one cup.
3.
Check that the lid is closed correctly.
4.
Ensure that the base unit and the base of your kettle are not wet.
5.
Place the kettle onto the base unit and plug in.
6.
Switch the kettle on by pressing down the On/Off switch located underneath the handle to the
On position.
7.
A blue light will illuminate inside the kettle when it is turned on.
Note:
The ON/OFF switch will also automatically return to the OFF position when it is finished
boiling.
Note:
You can stop the boil process at any time by pushing the ON/OFF switch up to the off position.
Tips:
Improve the quality of your drinks by always using fresh water.
Empty the kettle after each use.
Be economical and do not boil more water than you need.
8.
Ensure the kettle is switched off before removing it from its base. DO NOT remove the kettle
from its base while it is in operation.
9.
If you need to boil the kettle again, wait for a few seconds - allow the On/Off switch time to
reset. The delay should be no more than 20 seconds.
10. When you lift the kettle up from the base, you may see drops of water on the base. This is just
condensation from steam.
11. To avoid splashing or spilling, pour the kettle slowly and do not over-tilt it.
WARNING!
Never remove the lid during boiling. If the water inside the kettle has just boiled, the
kettle will be full of steam. The steam will escape as soon as the lid is opened.
Boil Dry Protection:
•
Your kettle will switch off automatically if you try to use it with too little water or if it is empty.
•
If this happens, ensure the ON/OFF switch is in the off position, remove it from the base unit
and allow it to cool down before re-filling.
•
Wait at least 15 minutes for the cut-out to reset before refilling with cold water and boiling.
Washable Filter:
•
Your kettle is fitted with a removable filter. The filter helps to prevent lime-scale from getting
into your drink.
•
The filter should be cleaned regularly, in particular if there are noticeable deposits left on it, or
if pouring is affected in any way.
•
To clean the filter, rinse it under the tap.
