9
Note:
For optimum results, keep a distance of at least 5cm between the steamer
and the garment or fabric.
5. The unit will now operate continuously until the trigger is released or the unit
is unplugged from the mains.
The Brush Attachment:
1. This appliance is complete with a brush attachment, ideal for use with suits
and other similar garments.
2. To attach the brush to the main unit, line up the hole at the bottom of the
attachment with the small tab underneath the steam nozzle and push it in
until it locks into place.
3. Once the underside of the brush is firmly secured into place, push the top part
of the attachment up and back until it slots into place on the main body of the
unit.
4. The brush attachment is now ready for normal use.
Note:
Ensure the attachment is firmly secured before attempting to use it.
6 - Troubleshooting
Problem
Solution
No operation.
• Ensure the appliance is plugged into the mains and that the
socket switch is in the ON position.
• Ensure the water tank has been filled.
• If using the unit for the first time or after a long period, press
the steam trigger for approximately 1 minute before using the
unit. This helps push the water through the steam pipe.
• Check that the fuse is not damaged. Replace the fuse if
necessary.
The unit is vibrating and making a
loud noise.
• The water tank is running low. Refill the water tank as
detailed in the ‘Filling the Water Tank’ section.
• There may be limescale in the water tank. De-scale the
unit as instructed in the ‘Cleaning and Care’ section of this
instruction manual.
There is a strange smell emitting from
the unit on first use.
• This is normal. The smell derives from oils used during the
manufacturing process, and will fade away after a few uses.
The unit is leaking.
• The unit has not heated up sufficiently yet. Allow the unit to
heat up fully before attempting to use.
White flakes are coming out of the
steam holes during operation.
• There is limescale in the water tank. De-scale the unit
as instructed in the ‘Cleaning and Care’ section of this
instruction manual.
The unit is in operation but there is
no steam.
• If the unit has not been used for a while, an airlock may have
formed. Press the steam trigger for approximately 1 minute
before using the unit. This helps push the water through the
steam pipe.
• There may be limescale in the water tank. De-scale the
unit as instructed in the ‘Cleaning and Care’ section of this
instruction manual.
• The unit has not heated up sufficiently yet. Allow the unit to
heat up fully before attempting to use.
