tousek
/ E_GSM-420-RS868_00 / 07. 05. 2018
- 3 -
1. General
GSM-receiver GSM 420-RS 868
Technical data
GSM-receiver GSM 420 RS 868, 2-channels
power supply
230Va.c.
SIM type
Standard
max. relay load
10A
receiver frequency
868,3MHz
operating temperature
-20°C to 50°C
programmable transmitter
100
protection class
IP20
dimensions
70 x 90 x 60mm
telephone module
SIM900 QBand
article no.
13280280
Attention
• Check with your mobile provider whether the SIM
card can send and receive SMS.
• Note: A phone number can only be saved once.
General information
The GSM 420-RS 868 is a reception device that commands two outputs and two independent signal inputs via the GSM (SMS)
cell phone network and radio transmission. It is fitted with two independent outputs and two independent inputs. It is possible to
configure the device either by sending commands via SMS or through a serial interface of a PC. Adjustments of telephone
numbers, time, stoppages, entrance and exit activations, alarm messages as well as a reset or status report can be done. In
general the activation of all commands sent by a cell phone will force the memorised and associated numbers to be called
and an SMS message to be sent to them. The product is also fitted with a radio receiver interface for RS868 radio controls. It
is supplied with an internal 868MHz antenna and has the possibility to be fitted with an external antenna if reception is poor.
Features
• 2-channel GSM-receiver with 2 potential-free N.O. bzw.N.C.
Outputs, which can also be controlled via transmitter and
integrated 2-channel RS 868 radio receiver.
• The two relay outputs with the operating modes ON / OFF,
pulse or time controlled (from 0 to 9999 sec.) arset via SMS.
• 1st channel (OUT 1) can be controlled via call, SMS and radio
2. Channel (OUT 2) can be controlled via SMS and radio
• Two inputs (IN1, IN2) to which an SMS can be assigned.
• In case of an event (eg Power ON Reset), the SMS and / or
telephone calls can be sent to max. 8 telephone numbers.
• adjustment and programming through PC with serial interface
connection possible. Memorising of installation data and
personalisation of numbers and assignment of personal data.
• function indications via LED.
• the possibility of inserting and cancelling up to 300 telephone
numbers with gate opening functions, if the number in ar-
rival corresponds to one of the memorised numbers the
corresponding output relay is activated.
• suitable for DIN rail mounting.
•
70
90
60
