CLEANING AND MAINTENANCE
CLEANING
Frequent cleaning is recommended to insure proper function, optimised light output,
and an extended life. The frequency of cleaning depends on the environment in
which the fixture operates: damp, smoky or particularly dirty environments can
cause greater accumulation of dirt on the fixture’s optics.
Clean the external lens surface at least every 20 days with a soft cloth to
avoid dirt/debris accumulation.
Never use alcohol, solvents, or ammonia based cleaners.
MAINTENANCE
Regular inspections are recommended to insure proper function and
extended life. There are no user serviceable parts inside this fixture, please
refer all other service issues to an authorised TourPro Lighting Company
service technician. Should you need any spare parts, please order genuine
parts from your local TourPro Lighting dealer.
Please refer to the following points during routine inspections:
•
A detailed electric check by an approved electrical engineer every three
months, to make sure the circuit contacts are in good condition and prevent
overheating.
•
Be sure all screws and fasteners are securely tightened at all times. Lose
screws may fall out during normal operation resulting in damage or injury
as larger parts could fall.
•
Check for any deformations on the housing, colour lenses, rigging hardware
and rigging points (ceiling, suspension, trussing). Deformations in the
housing could allow for dust to enter into the fixture. Damaged rigging
points or unsecured rigging could cause the fixture to fall and seriously
injure a person(s).
•
Electric power supply cables must not show any damage, material fatigue or
sediments. Never remove the ground prong from the power cable.
Page 10
TourPro LED Pin Spot - Manual v1.1
