Common problems
cause
solutions
The saw blade is too
slow
1. External cable extension cord is too light or too
long
1. Replace the cable with suitable size
2. Low voltage
2. Contact the local power company
3. The wrong voltage of the motor
3. Check the motor terminal box and connect
the correct voltage
Vibration is too large
1. Uneven floor
1. Adjust the position and place on the flat
surface
2. Blade damage
2. Replace the saw blade
3. The belt is badly worn
3. Replace the belt
4. Bend the pulley
4. Replace the pulley
5. The motor installation is too loose
5. Tighten the bolts of the mounting motor
6. Excessive clearance of lift structure
6. Adjust the lifting structure
7. The fastener is too loose
7. Re-lock the firmware
The wood bounces
back or pushes hard
1. The parallel degree of material baffle is
undesirable
1. Adjust the parallel degree of the material
baffle
2. Not parallel to blade and saw blade
2. Adjust the relative saw blade parallel to
the blade
3. Uninstalled material baffle feeding
3. Install the material baffle
4. Not installed with knife board
4. Installation and cutting board
5. Blade damage
5. Replace the saw blade
6. Not pushing wood until it passes through the
saw blade
6. Push the wood until it passes through the
saw blade
Saw blades cannot be
raised or deflected
1. The lifting structure locks too tightly
1. Rearrange the lifting structure to loosen
the tightness
2. The sawdust block
2. Clean the sawdust thoroughly and
lubricate it
The ruler can’t be
shown by the ruler
1. Battery drain
1. Replace the battery
The main saw speed
cannot be displayed
1. Sawdust blocking photoelectric switch light
sensor
1. Clear the sawdust
2. The belt exceeds the sensing distance
2. Adjust the detection distance of
photoelectric switch
Automatic typesetting
cannot load files
1. File format error
1. Loading the correct arr format file
2. Error of storage location of scan source file2.
Error of storage location of scan source file
2. The source file is stored in the specified
folder
-32-
