Wanderfull Technical Manual
6
Wanderfull controller configuration
Starting the controller
Unpack the unit and plug it to electricity through the power outlet port located in the
back. Once the controller is powered up, all LED indicators will be lighted up and emit red
light. The LED Indicators in the Wanderfull controller are for the Internet, Z-Wave, COM,
IR, and RS232.
Then, through the Ethernet port, plug in the network cable. Once the cable is plugged in,
two green LED lights, located on either side of the ethernet port will be turned one, one
flashing and the other will be on countinuosly. In addition, the LED light for the Internet,
on the front of the controller, will turn green.
There are two ways to connect to the controller:
1.
Through a local network
–
the controller gets an IP address. With the help of any IP
scanner tool, find the controller’s address.
Usually, the controller MAC address is
F8:DC:7A:XX:XX:XX and the manufacturer is Variscite Ltd.
Put the controller’s address
in your browser.
Internet LED Indicator
emitting GREEN
light
connected
to
the
Cloud
blinking RED light
no Internet connection
blinking YELLOW light
data is being transferred
Z-Wave LED Indicator
blinking GREEN light
transferring data
blinking RED light
no connection can be
established
blinking YELLOW light
pairing mode
COM LED Indicator
blinking GREEN light
transferring data
blinking RED light
no connection of any type
