TouchTunes DA415, Quick Start Manual

Page: 17 / 20

Amplifier Conversion
17
2. Connect a standard category 5 cable with RJ45 connectors from the Zone 1 output on the
MJS to the Zone A input connector on the DA415 amplifier.
CAUTION: Incorrect speaker installation or speaker wiring configuration can cause
severe damage to the amplifier. If you have not already done so, please refer to
“Speaker Wiring Guide” on page 11 before proceeding.
3. Connect left and right speakers to the DA415 by pressing their euroblock connectors firmly
into the left and right channel audio output connectors for Zone A on the DA415 amplifier.
4. Optional : Connect a standard category 5 cable with RJ45 connectors from the Zone 2 output
on the MJS to the Zone B input connector on the DA415 amplifier.
5. Optional : Connect left and right speakers to the DA415 by pressing their euroblock
connectors firmly into the left and right channel audio output connectors for Zone B on the
DA415 amplifier.
6. Power up the unit by connecting the power cord between a properly grounded wall outlet
(AC 120V /60Hz MAX 1000W) and the power connector on the amplifier.
Amplifier Conversion
It is possible to convert a DA415 amplifier from a 3-channel to a 4-channel version, and vice-
versa, by changing the amplifier’s I/O board. Such a procedure should be undertaken by
qualified service personnel only.
Note: TouchTunes does not recommend replacing a DA415 amplifier’s I/O board with that of a
different version, as complications may ensue should the amplifier require subsequent
servicing.
For technical information and replacement parts, please contact TouchTunes.