Touchland KUB Basic M280, User Manual

Page: 8 / 13

14 15
STEP 3
Install the sanitizer REFEEL Cartridge
1. Open dispenser by pushing the door.
2. Remove the red cap from REFEEL CARTRIDGE.
3. Place the REFEEL CARTRIDGE inside the dispenser (you need
to read the frontal side as showed below in the drawing) and
ensure that the it is sitting properly in the pump house.
Start using your dispenser
Place your palm under the sensor.
Note: May few activations are needed
before the device starts dispensing the
liquid after refeel change.
To receive additional product, remove
hands from below dispenser and repeat
action again.
STEP 4
4. When REFEEL
cartridge is properly
placed indicator light will
blink GREEN.
5. Close the door of the
dispenser.
KUB BASIC (Model: M280) only
Connect external supply
KUB PREMIUM (Model: M280L) only
Charge the battery
1. Insert the USB cable into the USB charger / Accessory port.
Caution: Use only charging devices approved by Touchland. Using other
accessories may invalidate your warranty and may cause damage.
2. Connect the USB cable to a 5V/1000 mA USB charger, and
then plug the USB charger into a standard outlet.
3. Once connected to the plug, batteries will not be charged.
Device will only be powered by the cable.
Your device is powered by a rechargeable, standard Li-Ion battery.
Use only with HJ-0501000B2-zz supply unit, suffix zz changes
as per the different world plug configurations (5V DC - 1000 mA).
The battery comes partially charged. You can use the device
while charging.
1
>
2
>