The battery indicator will flash a red light indicating the device is charging. The device
battery is full when the battery indicator illuminates a steady blue light.
A fully charged device should last for about 60 minutes of continuous use. This device
can be used approximately 30 times based on a 2-minute use.
Caution: Do not attempt to replace the device battery.
5. How to Use
To ensure the correct operation of this device, please read the instructions carefully before
use.
5.1 Remove/Attach the Trimmer Head
Remove: To remove the trimmer head, grab the device with one hand (please be
careful not to grab the touch switch sensor area), and use the other hand to rotate the
trimmer head counterclockwise. Pull to remove the trimmer head. Remove the inner
blade from the outer head. (Picture 2)
Attach: Insert the inner blade into the outer head. Place the trimmer head on the device,
and rotate it clockwise. Make sure you do not touch the touch switch sensor area when
attaching the trimmer head. (Picture 3)
5.2 Trimming Steps
Remove the protective cap. When you grab the device on the touch switch sensor area
and the trimmer head touches the nostril, the device switches on automatically.
(Picture 4)
Slowly insert the tip of the trimmer head into your nostril. Do not insert the tip of the
trimmer head deeper than 0.5cm. (Picture 5)
After using the device, you may notice some residual hair inside of your nostril. Use a
tissue paper or a cotton swab to remove any residual hair. Clean the device after each
use.
※
Area of use: nose.
※
After each use, clean the device with a clean slightly wet cloth. Remove the outer head
and inner blade, clean with the cleaning brush, and rinse it with water. Afterward, insert
the inner blade into the outer head, place it on the device, and rotate clockwise. Put the
device protective cap on. Store the device in a dry, well-ventilated place to extend its
lifetime.
