■ Shown below is a reference mounting drawing.
Determine the mounting position depending on the situation of the site.
■ Leave 130mm or more of space to the left of the paper holder so that a
paper roll can be set.
Warning
〈Mounting of YA87〉
■ Use plywood with a thickness of 12mm or more as the mounting
surface.
■ If the mounting surface is a thin wall, reinforce it with a wooden
board with a thickness of 30mm or more beforehand and then
mount the product.
■ If the mounting surface is a tile or concrete wall, use the provided
resin plug etc.
〈YA87〉
〈YT87S5・YT87S7〉
100
〈YH87〉
WARNING
■Use the provided wall mounting screw for
mounting the product.
Not doing so could cause the mounted product to become
unstable and fall to result in injury.
WARNING
■After mounting the product, check that it
does not rattle.
If the product rattles, it could come off or the wall could
be damaged, causing the user to fall down to get injured.
20
①Mark hole positions with a
scriber so that the mount
can be mounted horizontally
and drill pilot holes with a
diameter of 6mm and a depth
of 40mm or more.
②Drive the provided resin plugs
into the pilot holes and fasten
the mount with the two wall
mounting screws (pan head
tapping screw φ4.5×40).
Check that the mount is
installed horizontally.
③Insert the main body all the
way in and fasten it with the
two main body assembling
screws (cross recessed head
countersunk screw M4×8).
Mounting position
Preparation before mounting
Wall face
Wall face
Reference mounting height 1700
Reference mounting height
1200
Floor face
Reference mounting
height 650
Mounting method
Wall mounting screw position
Pilot hole
Resin plug
Mount
Wall mounting screw
(Pan head tapping screw φ4.5×40)
Main body assembling screw
(Cross recessed head countersunk screw
M4×8)
Main body