16
❷
❶
❸
❷
❶
维修保养
Servicing procedures
更换冲水阀
Replacing the Flush Valve
1.
Ҿ༶ѰটԢ٤ࡾᅾè
Remove the splash guard and pull it out.
2.
5.
ট࣌ᇖ൜ট൴Ҿ༶࣌ᆭࡖè
Remove the hold-down bracket by pulling on the tab indicated.
3.
ܸхඪམᇖ࣐֬ඪً࢟Ɨಝޱφ༶ಁࡸഏ֬φ୭࣐
ྡྷԑඪè
Close the shutoff valve in the tank, and then push the button on the
actuator to flush the water.
4.
6.
টఖԑඪًƗ࿏ሎটۍè
Pull the flush valve up, and rotate the rods.
φህট൴Ҿ༶ಁࡸè
Push on the tab to remove the actuator.
7.
টԢ൏࿏ሎᆣ۸ሔᇉè
Rotate the whole unit as you pull it out.
ࢃԑඪً֬ۻটۍ౧ྃᇇႾҮè
Tilt the two pull-up rods of the flush valve to the right.
8.
ԑඪً၉ؑ֬ཤࡸढ़ၢҾ༶࣐ྡྷ౩ࢸࠎ۾ߗè
At the other end of the flush valve, the rubber piece can be
removed for cleaning or to be replaced.
9.
φᅽთഏඔཔ٘֬ҋᇮҧቛƗѓࢃਲ਼ࡸτሔߴඪམè
To install the parts back into the tank, do the reverse order.
17
清洁进水阀滤嘴
Cleaning the Filter of the Fill Valve
φഏඔҧቛƗܸх࣐ඪً࢟ƗಝޱҾ༶࣐ඪًè
൜ƗҾा࣐ඪًƗಝޱႯඪ౩༨ݝະƗࠎᆇ
Ⴏඞሷ౩ԩ༅è
φᅽთഏඔཔ٘֬ҋᇮҧቛƗѓࢃ࣐ඪًτሔߴჷ
দ֬໑ᇉè
1. Close the water shutoff valve, and then remove the fill valve as
described above.
2. As shown in the figure, disassemble the fill valve, and then either
clean the filter with water or use a brush to clean any dirt from it.
3. To install, follow the procedure in reverse to return the fill valve to
its original position.
Summary of Contents for WH172AT
