Toto Washlet S400 SW563 Instruction Manual Download Page 3

4

5

WARNING

Use only a mild dish detergent diluted with water to clean your Washlet. Do not use the
folloing to clean the Washlet.

Toilet bowl cleaner, household cleaner, benzene, paint thinner, powdered cleanser, or nylon
scrubbing pads.

Use of any cleaning product other than diluted dish detergent may crack the plastic and
cause injury to the user or may damage the hose resulting in water leakage.

Do not stand on or place heavy objects on top of the toilet.

To avoid injury or damage to the toilet unit, do not stand on or place heavy objects on top
of the toilet.

Do not raise the toilet seat or toilet lid while objects are resting on top of the toilet.

Lifting the toilet seat/cover with objects resting on them could cause the main unit to
become detached, resulting in injury.

Do not bend or crush the water hose.

Bending or crushing the water hose may result in water leakage.

When not using the Washlet over an extended period of time, drain the water out of the
hose and pull the electrical plug from the wall outlet.

Water left standing in the toilet hose over an extended period of time could cause irritation
to the skin.

Refer to Page 32 for instructions on draining the hose.

If water leakage should occur, always close
the water shutoff valve and then turn off the
water.

When installing the water drain valve with water filter, make sure that it is securely
tightened in its proper position.

Improper tightening of the water valve may result in water leakage.

Preventing damage due to frozen pipes and hoses.

Frozen water pipes will cause the main unit and the pipes to break, resulting in water
leakage.

Regulate the room temperature to prevent the pipes and hoses from freezing during cold
months.

Refer to Page 32 for instructions on how to prevent frozen pipes

To prevent sudden water leakage, do not remove the water filter and drain valve when
the water shutoff valve is open.

Refer to Page 30 for instructions on cleaning the water filter.

Do not install base plate to Washlet when not attached to the toilet.

Fire or damage may result.

To reduce the risk of burns, electrocution,
fire or injury to persons:

1. Close supervision is necessary when this product is used by, on, or near children or invalids.
2. Use this product only for its intended use as described in this manual. Do not use

attachments not recommended by the manufacturer.

3. Never operate this product if it has a damaged cord or plug, if it is not working properly, if

it has been dropped or damaged, or dropped in water. Return the product to a service
center for examination and repair.

4. Keep cord away from heated surfaces.
5. Never block the air openings of the product or place it on a soft surface, such as a bed or

couch, where the air openings may be blocked. Keep the air openings free of lint, hair,
and the like. 

6. Never use while sleepy or drowsy. 
7. Never drop or insert any object into any opening or hose.
8. Do not use outdoors or operate where aerosol (spray) products are being used or where

oxygen is being administered.

9. Connect this product to a properly grounded outlet only. See Grounding Instructions.

10. Reservoir should be filled with water only.

WARNING

Save these instructions.

Do not use this product while smoking.

To avoid the risk of fire, do not smoke while using this product.

To reduce the risk of electrocution:

1.

Do not use while bathing.

2.

Do not place or store products where it can fall or be pulled into tub or sink.

3.

Do not place in or drop into water or other liquid.

4.

Do not reach for a product that has fallen into water. Unplug immediately.

DANGER

Grounding Instructions

This product should be grounded. In the event of an electrical short circuit, grounding reduces
the risk of electric shock by providing an escape wire for the electrical current. This product is
equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged
into an outlet that is properly installed and grounded.

DANGER

- Improper use of the grounding plug can result in a risk of electric shock.

If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to
either flat blade terminal. The wire insulation having an outer surface that is green with or without
yellow stripes is the grounding wire.

Check with a qualified electrician or serviceman if the grounding wire instructions are not
completely understood, or if in doubt as to whether the product is properly grounded.

This product is factory equipped with a specific electric cord and plug to permit connection to a
proper electric circuit. Make sure that the product is connected to an outlet having the same
configuration as the plug. No adapter should be used with this product. Do not modify the plug
provided - if it will not fit in the outlet, have the proper outlet installed by a qualified electrician. If
the product must be reconnected for use on a different type of electric circuit, the reconnection
should be made by qualified service personnel.

If it is necessary to use an extension cord, use only a three wire extension cord that has a three
blade grounding plug, and a three-slot receptacle that will accept the plug on the product.
Replace or repair a damaged cord.

Introduction

DISCONTINUED

Summary of Contents for Washlet S400 SW563























Reviews: