Thermostat Shower Mixer
For best results, be sure to read the following installation instructions and use the product only as described in the manual.
03C451E
2009.11
Important Safeguards
(For your safety, please follow the instructions below.)
Installation Manual
Do not disassemble or modify the item
in any way not described in this manual.
If the system is broken, property damage, scalding and other
injuries are likely to occur due to water leakage.
Do not fit the pipe in opposite the intended
temperature.
Burns may result from confusing hot water for cold.
Do not use hot water that is 85℃ and higher
If you use hot water over 85℃, the life of the faucet will be
reduced, if it is broken, property damage, scalding and other
injuries are likely to occur due to water leakage.
If you want to clean the filter, shut off the stop
valve first and do not open the cover
abruptly.
To use hot water as shown in the scale, you
must adjust the temperature.
If you do not use hot water as shown in the scale according to
the specifications, you may be burned.
Hot water expelled when removing the cap can burn you and
cause injury. Use caution.
Do NOT
Do Not
disassemble
Mandatory
Warning
Warning
Read the Important Safeguards section thoroughly before installing the product.
Warning
Caution
Ignoring these symbols may result in
death or serious injury.
Ignoring this symbol may result in
injury or property damage.
Absolutely Do NOT.
Do not disassemble.
Mandatory!
●The following table demonstrates
the use of safety symbols in this
manual.
Do not impact violently
If it is broken, property damage, scalding and other injuries
are likely to occur due to water leakage.
Do NOT
Caution
The shower tower should not be used as a
handrail or be used to hang objects.
If the shower tower or the supporting wall is
damaged, it may cause injury and leakage.
Hot water side
Cold water
side
Less than
85℃
40℃
filter, cold side
Filter,
hot side
stop valve
shut
Shower Tower
Cap
Model TMC95 V101＊
●The following symbols indicate safe and proper use
of the product. Failure to observe them may result in
injury or property damage.
The symbols and their meanings are as follows:
Mandatory
reinforced
Specifications
Cold and hot
water pressure
Min.necessary
pressure
0.75MPa(static)
0.15MPa(flowing pressure)
Less than 85℃
Water from river or the well for drinking
1〜40℃
For a general family bathroom
Max.use temperature
Suitable water quality
Suitable ambient temperature
Usage
Sealing agent must be applied around the
installation hole
If sealing agent is not applied, when the wall gets wet, the
shower tower may become detached or the wall may be damaged,
injury may occur.
Read the installation method of the substrate
carefully, confirm the substrate has enough
strength or reinforcement is installed.
Otherwise, the shower tower may become detached and the wall
may be damaged, injury may occur.
After installation, confirm that the shower tower
is stable
If the shower tower is unstable, it will become detached and
the wall will be damaged, injury may occur.
Caution
Must be installed on a shower wall or area
of equal support strength.
Direct installation on weak mud or plaster walls may result in
detachment of the shower tower of damage to the wall: resulting
in injury.
Max. pressure
No
Shaking
1/6
See next page
