23
24
A
How to Use
The recommended temperature setting for the water heater is 50°C to
60°C to ensure a comfortable discharge temperature.
For safety, the structure is designed to prevent a discharge of very hot
water.
(If the temperature control handle has been set correctly, then the
maximum temperature at which water can be discharged is approximately
45°C.)
A-1
How to adjust the temperature
Turn the temperature control handle.
Use the “40” mark as a guide and adjust the “safety button” to your desired
temperature.
For water hotter than about 40°C, keep the safety button pressed while
turning the temperature control handle.
A-2
How to adjust the fl ow rate
Turn the fl ow adjustment handle.
Turning the fl ow adjustment handle counterclockwise increases the fl ow
and turning it clockwise decreases the fl ow.
* Turning the fl ow adjustment handle all the way to the right stops the fl ow,
but please use the shower Open/Close button to stop the water.
A-3
Discharging/stopping the water (hot water)
Discharging water (hot water)
Press the Open/Close button and water will come out.
Stopping the water (hot water)
Press the Open/Close button again to stop the water.
A-4
Setting the temperature control handle
Turn the temperature control handle all the way to the side where water
comes out of the hand shower.
Turn the temperature control handle to the position where water at the
appropriate temperature (about 40°C) comes out, regardless of the scale.
Remove the temperature control handle.
Attach the temperature control handle at the position of the “40” mark.
After fastening the handle, check that water still comes out at the
appropriate temperature (about 40°C).
Sometimes water may drip from the shower for a while after the
shower is turned off .
This is a discharge of the residual water inside the shower head.
If it does not stop even after a few minutes, then make sure that the
handle is completely closed.
An intake noise may be generated inside the shower head due to the
mixing in of air. This is not a failure.
EN
