and needs readjusting. The simplest way is to adjust the phase of your system is
to have someone vary the PHASE dial as you are sitting in the listening position.
The Totem
KIN Mini Sub
is equipped with an automatic standby mode. If the unit
does not receive a signal, it will automatically go into “standby”. This feature
eliminates the need to turn the subwoofer off after each listening session, The
Totem
Kin Mini
subwoofer will automatically resume power one a signal is sent to
the sub.
Use the low-pass FREQUENCY dial to adjust the cut-in frequency of the
subwoofer. (usually between 50 and 70 Hz for floorstanding speakers and 70Hz
and up for monitor speakers)
Placement
When using the Totem subwoofer in a stereo setup its ideal location between the
main speakers or right beside them. When the Totem subwoofer is used in a
home cinema system it is recommended to place it in a corner. Be careful not to
place the subwoofer too close to the corner, or it will start to sound congested,
causing detail loss. Also make sure not to place the sub equidistant from the two
walls in your corner. As every room is different, experimentation is the key to
determining the optimal location for the Totem subwoofer.
Always keep in mind that frequency response and output level can be
significantly affected / influenced by placement all depending on the room’s
acoustic properties.
Caution!
This subwoofer has electronics built into the cabinet. Do not place the
cabinet next to sources of heat such as furnace registers, radiators, etc. Do not
place the unit near sources of excessive moisture, such as evaporative coolers,
humidifiers, etc. The power cord should be routed in such a way that it will not be
walked on, pinched, or compressed in any way that could result in damaging the
insulation or wire.
8
Summary of Contents for KIN MINI Sub
Page 4: ......
