TotalSeat A50, Operation Instructions Manual

Page: 8 / 12

13 12
Method Of Usage Method Of Usage
6.Am rest installation
Find out the plug respond to the arm rest on the bottom of the seat frame, and
through out from the square hole which on the fixed steel board.(figure 1)
When the plug out from the square hole on the steel board, respond to every
connecting plug( figure 2)
( Figure 1) ( Figure 2)
Draw out the plug on the bottom of the seat frame and connect with the arm rest
joint, air pipe responded to the right place (figure 3)
After connect the responded connector, insert it gently through the square hole on
the bottom of the seat frame, be careful to avoid to fold the air pipe (figure 4)
( Figure 3) ( Figure 4)
As figure, the pin on the arm rest respond to the box on the fix board, the steel
board respond to the groove of arm rest.(figure 5)
Hold the arm rest with your hands, pin respond to box on the front part of the steel
board, and pin respond to box on the behind of the armrest,( check the connect
wire whether it is insert in to the bottom of the armrest frame, avoid to get stuck),
( Figure 5) ( Figure 6)
Note: the connect wire must be
insert in the right place, avoid to get stuck
Arm rest covered on the fixed steel board, then press the armrest make sure the pin
into the box on the fixed steel board, and pull it with your hand to check it is fasten
tightly.(figure 7)
Find out the install hole on the front part of the fixed steel board, screw the screws
with hex wrench. £Figure 8£
Find out the install hole on the behind part of the fixed steel board, screw the screws
with hex wrench, finish the installnation, the same installnation of the two armrest.
( Figure 7)
( Figure 8)
( Figure 9)
PRESS IT
DOWNW
ARD GENTL
Y
Armrest
Seat cushion
Calf rest
Figure: hex head screw
fixed in front part of armrest
Armrest
back cover
Figure: hex head screw
fixed in behind part of armrest
Pull
INSERT INTO THE
BOTTOM OF
THE SEAT FRAME
7.
Upper armrest installation
( Figure 1)
( Figure 2)
Air pipe and trumpet line in backrest cross upper armrest and pipe hole. Two
guide pillars of upper armrest insert relevant hole on backrest cover(Figure 1).
Upper armrest pressed tightly by hand. Fixed the upper armrest on armrest
cover by two cross recessed pan head screws(Figure 2)