6
7
PRIMING AND FILLING
It is important to “prime” a new atomizer
head before first use. Failure to do so
can cause the atomizer coil to overheat,
resulting in a burnt taste and sometimes
irreversible damage to the atomizer head
requiring early replacement.
Remove the mouthpiece by pulling straight
off, and unscrew and remove the tank
assembly from the pipe body. Unscrew
the tank base to reveal the atomizer head.
Prime the atomizer head by dripping a
few drops of e-liquid on the side e-liquid
inlets of the atomizer head. Fill the tank to
just below the height of the central air tube
as shown in the diagram. Avoid allowing
liquid into the central air hole. Screw the
tank base back into the tank, then screw
the tank back on to the pipe body. Refit
the mouthpiece by pushing firmly over
the tank, being careful to ensure correct
orientation of the alignment tab.
Note: After priming a new atomizer head
and filling the tank with e-liquid, it is
recommended to wait 5 minutes to ensure
the atomizer head is fully saturated with
e-liquid.
FITTING THE BATTERY
To fit the battery, invert the
Pipe X and turn the battery
cap anti-clockwise until it
falls free. Insert the battery
into its housing negative
side first, push the top cap
down so that its tabs align
with the cut outs in the Pipe
X body, and holding down,
rotate through one quarter
turn clockwise. The LEDs
will flash 3 times to indicate
successful insertion.
