14
15
VAPING
Press and hold the power button as you inhale
the vapour, the screen will display a vape timer
while the power button is held down.
ADJUSTING THE AIRFLOW
To adjust the airflow to your personal
preference, rotate the airflow control ring
located at the bottom of the tank. The more
area exposed behind the slots in the airflow
ring, the more open the air draw will be.
E-LIQUID LEVEL
To prevent the atomizer head from becoming
dry and burning prematurely, ensure the
e-liquid level does not drop below the cotton
inlets on the atomizer head, visible through
the glass section of the tank.
CHARGING THE BATTERY
To charge the battery, connect the charge
port on the battery to a USB port or suitable
wall adaptor with the supplied charging cable.
The screen will display an animated battery
icon while charging, once the battery is fully
charged the screen will switch off completely.
REPLACING THE ATOMIZER HEAD
Remove the tank from the arc Sigma battery
by unscrewing at the tank base. Invert the tank
and unscrew the base. Remove the atomizer
head from the tank by pulling, and insert a new
atomizer head. Before fitting a new atomizer
head, remember that it will need priming
as described in the section “Priming the
Atomizer Head”.
Reminder:
After priming a new atomizer head
it is recommended to wait 5 minutes before
vaping to ensure the atomizer head is fully
saturated.
STEALTH MODE
If stealth mode is enabled, the display will not
activate when pressing the power button to
vape. The display will still activate whenever
the adjustment buttons are pressed to make
changes to wattage. To enable stealth mode,
ensure the arc Sigma is switched on, then
press and hold down the power and down
adjustment buttons at the same time, the
screen will display “Stealth ON” when enabled.
Repeat the process to disable stealth mode,
the screen will display “Stealth OFF” when
disabled.
USING YOUR ARC SIGMA
