SAFETY INSTRUCTIONS
Please note: Before assembling and putting the pump into operation, in all cases read
through the operating manual. For safety reasons, those persons who have not read through
the operating manual may not use the pump. The pump is intended for use ONLY by adults
who have fully read and understand these instructions. Whenever Water and Electric are in
the same place there are risks of electrocution and serious injury or death. The pump is ONLY
intended for use with water or water based (aqueous solutions) which have a content of at
least 90% water. DO NOT use this pump for flammable,toxic, corrosive or irritant fluids.
a) The user is responsible towards third parties with regard to the use of the pump
(water installations, etc.)
b) Before putting into operation, a qualified electrician must check that the required electrical
safety measures are place.
c) The electrical connection is to be made via an electrical socket.
d) Check the voltage.The specified technical information on the label must correspond to the
voltage of the electrical equipment.
e) During the operation of the pump, persons may not remain in the pumped medium.
f ) The temperature of the fluid to be pumped may not exceed 35°C. In the event that
extension cables are used, they must be exclusively made out of rubber, type H07 RN-F,
and in compliance with norm DIN 57282 or DIN 57245. Never handle, lift or carry the pump
connected to electrical power by the cord. Make sure that the connection power outlet is
kept away from water and moisture and that the power plug is protected from moisture.
g) Before putting the pump into operation,check that the electrical cord and electrical residual
current circuit breaker are not damaged.
h) In the event that the pump is to be installed in a storm drain, one must subsequently close
the storm drain with a cover in order to safeguard the safety of pedestrians.
i ) Reinforce the mounting of the discharge pipe with the use of a pipe clip.The user of the
pump has the duty to take precautionary measures (installation of an alarm device,
back-up pump, etc.) for the avoidance and prevention of potential damages (such as
flooded rooms, etc.) due to faulty pump operation (because of breakdowns or defects).
On sandy or silty ground it is necessary to let the pump run hanging by a rope or chain or
to situate the pump on a suitable base in order to prevent the sinking of the intake section.
j ) In the event that the pump is damaged, the repair should only be made by an authorised
service agent. Only original replacement parts must be used.
k) The failure to correctly use, clean and maintain the pump or to modify the pump or its
accessories in any way other than that described in these instructions will prevent use for
accepting any responsiblity for damages,loss or injury.The following illustrate some of the
cases where claims be refused :
● Inappropriate repairs not made by an authorised agents
● Use of other than original replacement parts.
i ) The connecting cable of this device may not be replaced. In the event of damage to the
cable,the device should be scrapped.
m) Note this product has internal lubricant which may escape contaminating the water,
consequently the pump is not suitable for ponds with fish or other aquatic organisms.In
addition the pump can only be used to with water that is NOT for drinking at a later date.
The same rules apply for the accessories.
2
Summary of Contents for TWP311001
Page 7: ...OPERATION INSTRUCTION 7...
